Which parts of automobile rubber sealing strip are more important? You must know more about this problem. Next, Xiaobian will learn about it with you:
Before installing the glass, carefully remove the sundries in the notch, such as mortar, brick chips, wood blocks, etc. when placing the glass, carefully align the glass to ensure uniform clearance on both sides, and fix it in a timely manner to prevent collision, displacement and deviation from the center of the notch. The rubber sealing strip cannot be pulled too tightly, and the blanking length is 20-30mm longer than the assembly length. During installation, it shall be embedded in place, the surface shall be straight and in close contact with the glass and glass notch to make the stress around the glass uniform. At the corner, the rubber strip shall be cut off by an inclined plane, and glue shall be injected and bonded firmly at the cut-off point. When sealing and fixing the glass with sealant, the glass shall be squeezed with rubber strip or rubber block to leave glue injection gap. The glue injection depth shall not be less than 5mm. Before the glue is cured, the glass shall be kept free from vibration.
Before installing the glass, carefully remove the sundries in the notch, such as mortar, brick chips, wood blocks, etc. when placing the glass, carefully align the glass to ensure uniform clearance on both sides, and fix it in a timely manner to prevent collision, displacement and deviation from the center of the notch. The rubber sealing strip cannot be pulled too tightly, and the blanking length is 20-30mm longer than the assembly length. During installation, it shall be embedded in place, the surface shall be straight and in close contact with the glass and glass notch to make the stress around the glass uniform. At the corner, the rubber strip shall be cut off by an inclined plane, and glue shall be injected and bonded firmly at the cut-off point. When sealing and fixing the glass with sealant, the glass shall be squeezed with rubber strip or rubber block to leave glue injection gap. The glue injection depth shall not be less than 5mm. Before the glue is cured, the glass shall be kept free from vibration.
CONTACT US
sale hotline
13313392399